P
pep2k21
Benutzer
- Registriert
- 12.04.2021
- Beiträge
- 2
- Punkte Reaktionen
- 0
hello.
last night i found this place and get surprised. wonderfull thank you very much.
i have grundig 40 vle 6420 bh when plugged in, tv showed logo sometimes, not all the times, backlight on,
then led flashes blue about 5 times and everything goes off but led light stay blue. (today logo is not showing, only backlight try to start and goes off fast)
no response to remote except if i press channel +/- then blinks again, tries to start. once or twice, then led blue light go a bit soft blue and no response.
tried firmware from here, found 3 of them,
KYGRMR.-.-.-.-.V07.034.36,
KYGRMR.-.-.-.-.V07.034.39, and
KYGRMR.-.-.-.-.V07.052.00
for about half a second i could see the software upgrade process at 1% was starting on screen, then went off again and led blue flashing for about 1 or 2 min.after this blue led stay with no flash. same than at begin.
i read a few coments about similar errors ending with a main board replacement. i have a programmer is it a bad idea to try to program spi or nand?
it may be power board?
what do you think?
thank you very much
last night i found this place and get surprised. wonderfull thank you very much.
i have grundig 40 vle 6420 bh when plugged in, tv showed logo sometimes, not all the times, backlight on,
then led flashes blue about 5 times and everything goes off but led light stay blue. (today logo is not showing, only backlight try to start and goes off fast)
no response to remote except if i press channel +/- then blinks again, tries to start. once or twice, then led blue light go a bit soft blue and no response.
tried firmware from here, found 3 of them,
KYGRMR.-.-.-.-.V07.034.36,
KYGRMR.-.-.-.-.V07.034.39, and
KYGRMR.-.-.-.-.V07.052.00
for about half a second i could see the software upgrade process at 1% was starting on screen, then went off again and led blue flashing for about 1 or 2 min.after this blue led stay with no flash. same than at begin.
i read a few coments about similar errors ending with a main board replacement. i have a programmer is it a bad idea to try to program spi or nand?
it may be power board?
what do you think?
thank you very much